Nargesa H2 Two-Burner Propane Forge
The H2 has two independently operated propane burners and a usable chamber of 324 × 100 × 240 mm. A vermiculite divider is supplied to reduce the chamber volume when required. This configuration suits a forge shop alternating between short tips and wider ornamental blanks. The front opening is 280 × 100 mm and the side opening is 140 × 100 mm. Choose the access route for the part size and orientation. Show the supplier how the widest blank will enter and where it will be formed. Compare the work with small and larger loads and confirm the gas installation requirements in the manufacturer's documentation.
Price on request
Manufacturer: Nargesa · Spain
Technical specification
| Temperature | 1300 °C |
|---|---|
| Burners | 2 |
| Chamber (W × H × D) | 324 × 100 × 240 mm |
| Material max. | Ø80 mm |
| Openings | 280 × 100 mm front · 140 × 100 mm side |
| Gas use | up to 0.7 kg/h at 1 bar · ≈ 50 h on a 35 kg bottle |
| Fuel | Propane (LPG) |
| Safety | Electronic ignition, thermocouple valve, non-return valve, stainless gas hose |
| Insulation | Double compacted vermiculite |
| Machine dimensions (W × D × H) | 500 × 440 × 370 mm |
| Weight | 40 kg |
| Customs tariff code (HS) | 84171000 |
| Made in | Spain (Palau de Santa Eulàlia, Girona) |
Standard equipment
- Integrated adjustable bar support
- Stainless gas hose
Similar machines
- Power hammer · 50 kg
Nargesa PH50 Pneumatic Power Hammer with Built-In Compressor
The PH50 is a pneumatic forging hammer with a built-in compressor and a 50 kg nominal dropping weight. Nargesa lists 240 blows per minute. Different dies and tools allow heated steel to be drawn out and shaped. For a transition from solid bar to a reduced end, specify the length and shape of the transition. The dies and clearance around them determine which areas remain accessible. Check support and foundation requirements in the machine documentation. Request a trial on the starting section used in production. Measure finished length and cross-section and inspect the surface marks.
NargesaPrice on request - Gas forge · 3 burners
Nargesa H3 Three-Burner Propane Forge
The H3 is a propane forge with three independently operated burners. The usable chamber is 464 × 100 × 240 mm and the front opening is 420 × 100 mm. The wide access allows room to plan several bar ends or a broad blank. When the forge supplies a press or hammer for a batch of ornamental parts, define how many blanks must be ready per cycle. Give the supplier the section size, quantity and layout in the chamber. Check heat distribution with a representative load. During the demonstration, compare blanks from the centre and ends of the arrangement. Evaluate whether transfer to the next operation matches the planned production cadence.
NargesaPrice on request - Gas forge · 1 burner
Nargesa H1 Single-Burner Propane Forge
The H1 is a compact single-burner propane forge. Its usable chamber is 140 mm wide, 100 mm high and 236 mm deep. These dimensions are a useful starting point when sizing a forge for bar ends and short blanks. For a forged fence picket tip, specify the length that needs heating. Nargesa provides a removable rear door for access to the middle of a longer bar. Check the clearance around the forge and the stock support. Provide the section size and a typical batch quantity for a quotation. Compare the time to prepare the first piece and the rate at which heated stock can reach the next operation.
NargesaPrice on request