Tube and pipe benders
CNC roll benders and non-mandrel tube benders for round and square tube – compare capacity, radius and control.
- CNC tube bender · 3 rollers
Nargesa MC550CNC Three-Roll CNC Tube and Section Bender
The MC550CNC uses three driven rolls and independently positioned lower shafts. The CNC predicts bend radii and coordinates the axes through transitions between segments with different curvature. The configuration suits repeat batches of curved frames where one piece contains several radii. Long stock needs support and room to travel through the bend. The machine can work vertically or horizontally according to part geometry and available space. Submit the radii and transition points on the drawing. Measure the bent sample for remaining straight ends and compare the transition areas with the template.
NargesaPrice on request - CNC tube bender · 3 rollers
Nargesa MC650CNC Three-Roll Tube and Profile Bender
The MC650CNC combines three driven rolls with CNC radius prediction and axis interpolation. The lower shafts are independently positioned. The catalogue lists round tube capacity up to 101.6 mm with appropriate tooling. On a structural component with a long arc and a tighter transition, the entire contour must repeat after unloading. Define the beginning and end of each zone and the reference face on the section. For long stock, evaluate horizontal operation with supports. Inspect symmetry, transition areas and straight lengths on the trial piece. Ask the supplier to recall the saved programme and run a second length of stock from the same batch.
NargesaPrice on request - Tube bender · without mandrel
Nargesa CC60 CNC Non-Mandrel Rotary Tube and Pipe Bender
The CC60 CNC bends tube around a rotary die without an internal mandrel. Nargesa lists bends up to 180° with the appropriate tool. One listed S275 capacity is 2-inch Schedule 40 pipe with a 60.3 mm outside diameter. The machine suits parts with defined bend locations, such as handles, tube frames and U-shaped components. When a tube has several bends, the drawing needs the spacing and orientation of each bend plane. Match the working radius to the tooling proposal. Send a drawing with the bend angles, centreline radii and straight lengths. On the sample, measure the angle after release and inspect the section around the bend for ovality and wrinkling.
NargesaPrice on request - Tube bender · without mandrel
Nargesa CC90 CNC Non-Mandrel Rotary Tube Bender
The CC90 CNC bends tubes around a rotary die without a mandrel. Nargesa lists bends up to 180° depending on the tooling. Examples in the capacity table include 88.9 × 4 mm stainless tube and 60 × 60 × 4 mm square tube. For a tubular frame with multiple bends, define centreline radii, angles and tangent lengths. Select the die for the outside dimensions and material. With larger stock, check the sweep of the part between successive bends. Request a trial of the most demanding radius, angle and wall combination. Measure ovality, end locations and the straight length required for the mating assembly.
NargesaPrice on request