Wrought-iron profile machines
Embossing of flat and square bar, twisting, baskets and decorative tube work – for fences, gates and railings.
- Cold embossing · rollers
Nargesa NOA60 Cold Embossing Machine for Metal Sections
The NOA60 rolls a relief pattern into metal using profiled rolls. Nargesa lists capacities up to 60 × 60 mm for square tube and 60 × 10 mm for flat bar. A straightening unit with seven adjustable rollers is included. For railing or fence panels, choose the pattern around the visible face and the joint locations. Specify where the pattern should start and finish relative to the cut and assembly. A trial on the same section shows whether the texture is consistent along the stock. Lay several embossed blanks side by side. Check the pattern repeat, measure straightness and check fit in the frame after the section has passed through the straightener.
NargesaPrice on request - Cold forging · CNC
Nargesa MT500A CNC Cold Twisting and Bending Machine
The MT500A CNC cold-forms steel at separate twisting and bending stations. Nargesa lists capacities of up to 40 mm square solid bar for twisting and up to 25 mm square bar for bending. For an ornamental picket, define the twisted zone and the straight ends that attach to the frame. For a scroll, specify the outer contour and where the tail should finish. The tool sets the form, and the CNC setting lets the operator repeat the movement on the next pieces. Place two samples in the panel jig. Compare twist direction and pitch and check that the straight ends meet the mounting points.
NargesaPrice on request - Cold forging · automatic
Nargesa MT150A Automatic Twisting and Bending Machine
The MT150A forms ornamental bars and curves with interchangeable tooling. Nargesa lists solid square-bar capacity up to 20 mm for twisting and 16 mm for bending. The part programmer stores the movement for repeat pieces. For pickets with a short twisted zone, dimension its start and finish from the cut end. This places the visible pattern at a consistent height in the panel. For hooks, bends and scrolls, confirm the actual tool and the straight length needed for clamping. Place the sample parts against the panel frame. Measure the distance from the end to the start of the pattern and compare twist pitch and direction.
NargesaPrice on request