AONA Automatic Rotary Cold Cutting Machine for Pipe

This machine uses a cutting wheel for rotary cold cutting of pipe. AONA describes versions for steel, stainless steel and other materials, with suitability confirmed for the specific pipe. For a pipe that will receive a coupling or undergo further forming, the inside edge affects fit-up. On galvanised stock, include any coating requirements near the cut. Match the wheel to the material and wall thickness. Ask for a cut made on your actual pipe. Measure the bore around the cut and check the fit of the mating component before selecting the setup.

Price on request

Manufacturer: Aona Machinery · China

Technical specification

Standard equipment

• 2-year warranty – parts sent free by DHL
• 24-hour online support, operation videos
• Voltage to your country

Similar machines

• Roll cutting · 6 m

  AONA Automatic Pipe Roll Cutter with Hydraulic Feeding

  This roll cutting machine cuts pipe to length with automatic hydraulic feeding. AONA lists a length of up to 6 m. Ask the supplier to specify the maximum incoming stock length and maximum finished part length separately. For batches of duct parts, metal furniture or tubular assemblies, evaluate the full incoming stock length. Consecutive cuts need to stay within the length tolerance as the feed approaches the end of the pipe. Give the supplier the incoming and finished lengths and the expected lot size. Ask for a trial on one full stock length, the number of accepted pieces and the size of the end remnant. Confirm how finished pieces transfer to the next operation.

  Aona Machinery

  Price on request
• Cold roll cutting · Ø8–260 mm

  AONA Automatic Roll Cutter for Round Tubes Ø8–260 mm

  This version uses a rotating roller tool for cold cutting round tubes. AONA lists an Ø8–260 mm range. Wall capacity and the setup depend on the diameter, material and configuration. For short sleeves and spacers, both overall length and the usable bore after cutting matter. Compare samples at the smallest and largest sizes in your job using the actual steel grade and wall thickness. Measure several parts for length, ovality and the condition of the inside edge. Request a feed-to-discharge cycle time for each representative size.

  Aona Machinery

  Price on request
• Saw cutting · roller feed · 6 m

  AONA Automatic Tube Saw with Roller Feed

  Rollers position the tube for a programmed cut on the circular saw. The Machory configuration lists sections up to 100 × 100 mm with walls up to 2 mm and incoming stock up to 6 m long. This is a candidate for batches of straight blanks for panels, frames and stands. Compare the number of usable pieces produced from a full stock length. Account for saw kerf, any initial end trim and the remnant left by the feed system. Have the supplier cut the shortest and longest parts in your usual mix. Measure several consecutive pieces and check end squareness and edge condition on your actual material.

  Aona Machinery

  7 900 $ (≈ 7 059 €) · delivery not included
• Angle saw · 0–180°

  AONA Semi-Automatic Mitre Saw for Tubes and Profiles

  This semi-automatic circular saw makes mitre cuts on metal tubes and profiles. In the quoted setup a pneumatic cylinder clamps the part, then the saw feeds, cuts and retracts. The listed sections run from 10 × 10 to 100 × 100 mm with 1.5–2 mm walls. A typical job is cutting left- and right-hand mitres for a frame. Confirm the usable section size at the angle you need, since the cutting geometry changes with the angle and the orientation of the stock. Ask for a pair of matching cuts in your own section. Bring the ends together and check the joint gap, included angle and edge condition before welding.

  Aona Machinery

  6 500 $ (≈ 5 808 €) · delivery not included